Catalog

ST-301 “SPIDER“ – Wireline Analyzer

Wire lines analyzer ST-301 “Spider” is designed to detect and locate eavesdropping devices, galvanically connected to power and low-current wire lines in the inspected object. The analyzer uses both passive and active modes of operation. This allows detecting eavesdropping devices which are in active or in stand-by mode at the time of a sweep operation.

Modes of operation

• Low frequency amplifier.

• Wired receiver.

• Wired Non-linear junction detector.

• Reflectometer.

Functional capabilities:

• Detection and analysis of signals from cable (dynamic and electret) microphones in low-current wire lines;

• Activation of electret cable microphones by applying an in-line BIAS voltage for their detection

• Detection of eavesdropping devices signals, which are transmitting information via power and low current lines in the frequency range of 100 kHz … 180 MHz;

• Detection and evaluation of unauthorized galvanic connections to wire lines in the modes of non-linear junction detector and reflectometer;

• Measurement of direct and alternating voltage in the tested line.

The analyzer has an integrated electronic switch, which is designed to increase the efficiency of multiwire cable testing.

Automatic and manual modes of electronic commutator control allow connecting all combinations of wire pairs of the tested multi-wire cable that connects to the input connector of the switch. Automatic mode of operation and electronic commutator allow executing the various types of measurements in all combinations of multi-wire cables pairs for several seconds. Adapters, switches and cables, which are included in the kit, allow connecting the device to the most common types of wire lines.

Use of automated mode of analyzer, in combination with electronic switch, allows to carry out various kinds of measurements on all the possible combinations of pairs of multi-wire cable in a few seconds. Adapters, couplers and cables, which are included in the ST-301 SPIDER delivery set, allows to connect the device to the most common types of wired lines.

Technical Characteristics:
LOW FREQUENCY AMPLIFIER (LFA):
Frequency range	20 – 25000 Hz
Input resistance	200 kOhm
Adjustment range of gain	0 – 60 dB
The maximum signal amplitude on an input	10 V
Spectral density of noise voltage	6 nV/Hz
Bias voltage values	0, ±5, ±10, ±15, ±20, ±26 V
Form of representation of a signal	Oscillogram, Spectrogram
Measurement range on a direct current	±80 V
WIRE RECEIVER (WR):
Frequency range	0.1 – 180 MHz
Time of scanning of all range	0.3 – 1 sec
Minimum level of detected signal in AUTOMATED mode	– 60 dBm
Dynamic range	50 dB
Input resistance	50 Ohm
Demodulation	AM, FM
Bandwidth of the filter	180 kHz
The maximum allowed voltage in the cable	250 (AC), 80 (DC) V
Data representation form	Spectrogram, Oscillogram, Table
NON-LINEAR JUNCTION DETECTOR (NLJD):
Level (amplitude) of the probing signal	±14 V
Frequency of the probing signal	60 Hz
Separate indication of even and odd harmonics	yes
Minimum detectable level of non-linear distortion	0.1 %
REFLECTOMETER (REF):
Range of distances	3 – 150 m
Error of measurements	±0,6 m
The ability to work on cables under voltage	No
POWER SUPPLY:
The built-in lithium-polymer accumulator	3.7 V
Power consumption	< 1 W
Operating time at the maximum power consumption	> 3 hour
Charging interval of completely discharged accumulator	5 hour
WEIGHT AND DIMENSIONS:
Dimensions of the main unit	L165 x W98 x H40 mm
Mass of the main unit	0.47 Kg
Packaging dimensions	L390 x W310 x H170 mm
Mass of the kit in packaging	4.4 Kg

Catalog

ST-301 “SPIDER“ – Wireline Analyzer

Have a Question?

What would you like to know about this product?